TP5100 4.2v and 8.4v Dual One/Two Battery Protection Board is a double switch buck 8.4V, single cell 4. 2V lithium battery charge management chip. Its ultra-compact QFN16 package and simple external circuit, making TP5100 ideal for portable equipment so large current charging management applications. Meanwhile, TP5100 built-in input overcurrent, under-voltage protection, over-temperature protection, short circuit protection, battery temperature monitoring, reverse battery protection.
TP5100 has 5V-15V wide input voltage, dual battery trickle charge into pre-charge, constant current, constant voltage three-phases, pre-charge current trickle charge current through an external resistor adjustment, the maximum charge current up to 2A. TP5100 with a frequency of 400kHz switching mode makes it possible to use a smaller outer Suo device and the large current charging still maintains a smaller amount of heat.
TP51OO built-in power PMOSFET, anti-intrusion circuit, so no anti-intrusion protection and another external Schottky diode.
TP5100 4.2v and 8.4v Dual OneTwo Battery Protection Board
Features:
- Input voltage: 5-15V DC power supply.
- Charge status: full and unloaded blue lights, charging red.
-
Double 8.4v / 4.2v lithium rechargeable single .
-
Programmable charge current. 0. 1A-2A .
-
Programmable steady precharge current 10% -100%.
-
Wide operating voltage, maximum reach I8V.
-
Red and green LED charge status indicator.
-
Chip temperature protection, overcurrent protection, under voltage protection.
-
Battery temperature protection, reverse battery shutdown, short circuit protection.
-
Switching frequency 400Khz, usable inductance 20uH and more.
-
PWR_ON Power battery for switching control.
Package Includes:
1 x  TP5100 4.2v 8.4v Single Double Lithium Battery Charging Board.
rakesh kumar (verified owner) –
almost good product.
rakesh kumar –
Rock (verified owner) –
Working fine
Rock –
Nitin Dhiman (verified owner) –
There is a little bit of a heating problem otherwise it is good.
Nitin Dhiman –
pratiksorathiya007 (verified owner) –
Please ensure you verify the polarity prior to usage. I accidentally damaged two of these. Heating issue is there in 8.4 mode.
pratiksorathiya007 –
deepsinghraman (verified owner) –
I contacted the manufacturer due to failures. The Circuit when used with DC adapters must have a series 0.1 Ohm resistor and a 100uF capacitor to prevent surge currents from damaging the IC. Haven’t had any failure since. Just a tip in case you see this going up in smoke.
deepsinghraman –
2009anandsingh (verified owner) –
Effective and efficient. Very stable. Not sure how to program it to use it for 2A
2009anandsingh –
Anil Saini (verified owner) –
Not sustaining for more than three days. it is going out of order very fast. Please arrange other reliable 8.4V charger module in future.
Anil Saini –
prasad (verified owner) –
Product is good, fast shipment but FedEx messed up every thing.
very much concerned about this.
prasad –