This is Thermistor 100k NTC with 1 Meter Cable Temperature Sensor for 3D Printer Reprap. The thermistor is a thermally sensitive resistor known for exhibiting a large change in resistance with only a small change in temperature.
It is important to note that a thermistor’s change in resistance is non-linear. It follows a pre-defined curve which is provided by the thermistor manufacturer.
Positive thermal coefficient (PTC) will increase in resistance with an increase in temperature, negative ones (NTC) will decrease. But the formula in practice is not linear, so sometimes an accurate table of measurements is better than the linear formula. These measurements can usually be found in the datasheet that accompanies the thermistor.
We also have a variety of 3D Printers and accessories from the Brand CREALITY at the best price in INDIA,
Features :
- 100k Ohm NTC Thermistor.
- NTC Thin Film Thermistor Cable.
- Nominal value: R25 (25 ℃) : (common) 1.5K, 2K, 5K, 10K, 20K, 30K, 47K, 50K, 100K, 200K, 500K, etc.
- Resistance precision: ± 1%, ± 2%, ± 3%.
- B value R25/50 (common) 3435k, 3600k, 3950k, 3990k, 4100k, 4200k, etc.
- B value accuracy: ± 1%.
- Recommend the use of parameters: R25℃ = 100 k B25/50 = 3950 k ± 1%)
Package Includes :
1 x Thermistor 100k NTC with 1 Meter Cable Temperature Sensor
Siddheshwar Chopra (verified owner) –
Perfect!!! Works very well with ender 3 v2 printer
Siddheshwar Chopra –
sabdulmannan387 (verified owner) –
very fast service
sabdulmannan387 –
Keerthi Kulkarni (verified owner) –
While the Thermistors are good, the wires connected and the connection to the wire are very fragile. They break down very frequently and become unusable after some time. At the other end too, the cables are open and with no connectors. You will have to solder a new wire with connector to use it.
Keerthi Kulkarni –