Stack Mamba F4 pro+V2 flight controller with your desired compatible ESC to build your F4 V2 pro flight controller. This F4 Pro + V2 has a Size of 36 x 36mm with Mounting Holes at the pitch of 30.5×30.5mm and its Net Weight is 13g. This Omnibus F4 Flight Controller equipped with Processor: STM32F405
 Features:
- Gyroscope: MPU6000 (reserved external gyroscope interface)
- Firmware: BetaFlihgt 3.2.0 OMNIBUSF4SD
- Support Receiver: PPM, SBUS, IBUS, DSM2/DSMX Receiver (UART1)
- Integrated with OSD, support BF Ground Station adjust OSD
- Adjust the PID by OSD by remote control
- Support Dshot Protocol
- Support SmartAudio, adjust the VTX by OSD (UART3)
- MicroSD card BlackBox
Package Includes:
1 x Mamba F4 Pro+ V2 Flight Controller
1 x Connecting Wires
triloksingh.ts97 (verified owner) –
good pcb but when vtx is on working it’s too hot good condition video tx in 500 mw but Rx setup is some different because Wich wire is show vcc gnd and signal wrong.actuly signal wire is just down the power led conector
triloksingh.ts97 –