Programmer
Showing all 19 results
-
Best Prices, USB Interface Module
USB TO UART TTL 5V 3.3V FT232RL Download Cable To Serial Adapter Module For Arduino
Best Prices, USB Interface ModuleUSB TO UART TTL 5V 3.3V FT232RL Download Cable To Serial Adapter Module For Arduino
SKU:- Standard interface layout, compatible with a variety of Arduinos such as the Pro Mini
- Original FTDI FT232 chip, stable performance
- USB power has current protection, using 500MA self-restore fuse
- RXD/TXD transceiver communication indicator
- With power, sending, receiving indicator, working status LED indicators
- Mini USB Port Connection
- Support 3.3V, 5V
SKU: n/a -
Best Prices, USB Interface Module
USB to RS485 Converter Adapter Support WIN7 XP Vista Linux Mac OS
SKU:- Fully compliant USB 2.0 standard, backward compatible with USB1.1
- Support System: Windows XP, Vista, Windows 7, Linux, MacOS, and WinCE5.0 drive
- Baud Rate Range: 75bps – 115200bps, up to 6Mbps
- Supports Plug, Play and hot-swap ( USB side)
- Better than using CH341D chip or similar chip to support the laptop USB port.
- Communication distance up to 1.2KM
SKU: n/a -
Best Prices, PIC Programmer
ST Link V2 Programmer For STM8 and STM32
SKU:- PCB installed inside of aluminum alloy U disk shell, portable, safe and reliable!
- Interface definition directly marked on the shell, clear, convenient and practical!
- 5V, 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
- Shell characters using laser engraving, never fade off! Permanent clarity!
- 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
- SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
- SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
SKU: n/a -
USB Interface Module
CH341A 24 25 Series EEPROM Flash BIOS USB Programmer with Software & Driver
SKU:- USB interface
- With CH341A chip
- Support 24 EEPROM and 25 SPI flash 8pin or 16pin chip
- With 24/25 status indicator lamp
- Support USB to TTL conversionSupport 24EEPROM and 25 SPI flash 8pin/ 16pin chip
- Recognize 25 series chip automatically
- Supports download STC series procedure of single chip
- SPI pin to support expanding the utility
- STC microcontroller supports a full range of program download
- Support expanding the utility by SPI pin
- With SOP8 SOP16 to DIP8 converter board
SKU: n/a -
USB Interface Module
USB to RS485 TTL Serial Converter Adapter FT232
SKU:- Baud rate: 300 – 9216000bps, automatically detecting the serial signal data rate
- Load capacity: support multipoint, each converter allows RS485 interface device to connect 32
- Interface Protection: TVS tube protection, USB self-recovery protection
- Support Windows98/ME/2000/XP/WIN7/Vista, Linux, Mac
- It can be up to 32 devices on the bus.
SKU: n/a -
USB Interface Module
USB to UART/ESP8266 Adapter Programmer for ESP-01 WiFi Modules with CH340G Chip
SKU:- Driver Chip:Â CH340G
- Supports all basic windows versions.
- The adapter plate integrated 1000μF solid capacitors to ensure the current supply
- The power supply will not be a problem to make WIFI module crashes unresponsive.
- Using 3225 SMD crystal oscillator, improve the stability of serial work, on a beautiful and tall.
- Working voltage: 4.5V – 5.5V (Onboard 3.3v LDO Regulator)
- Working current: 300mA (LDO regulator can supply)
SKU: n/a -
Best Prices, PIC Programmer
PICkit3 Debugger Programmer Emulator Controller Development Board
SKU:- Full-speed USB support using Windows standard drivers
- Real-time execution
- Processors run at maximum speeds
- Built-in over-voltage/short circuit monitor
- Low voltage to 5V (1.8 to the 5V range)
- Read/write program and data memory of the microcontroller
- Program up to 512K byte flash.
SKU: n/a -
USB Interface Module
TTL FTDI Transmitter USB For 3.3V/5V Dual power FT232RL MWC Programmer
SKU:- USBÂ Connector type: USB-Mini
- Chip Used:Â FT232RL
- Output Voltage 5v and 3.3v Indicator LEDs USB Connector
- Automatic detection of data transfer speeds up to 1Mbps
- Data exchange capability with an external interface with UART protocol
- Supports Windows 8, Windows 7,  Windows Vista, Windows XP, Linux, Mac OS X, Windows CE 4.2-5.2, Windows CE 6.0
SKU: n/a -
Audio Amplifier Module
AVR ISP 10 Pin to 6 Pin Adapter Board
SKU:- Made of high-quality material, practical and durable
- No. of Pinon USBASP side: 10.
- No. of Pinon Device under programming side:Â 6.
- Connector type on USBASP side:Â Male.
- Connector type on Device under programming side:Â Female.
- Header Pin Pitch: 2.54mm (0.1in).
- Pin Numbers Text: Yes on Top and Bottom sides of every pin.
SKU: n/a -
PIC Programmer
PICkit3 Debugger Programmer Emulator Controller Development Board
SKU:- Full-speed USB support using Windows standard drivers
- Real-time execution
- Processors run at maximum speeds
- Built-in over-voltage/short circuit monitor
- Low voltage to 5V (1.8 to the 5V range)
- Read/write program and data memory of the microcontroller
- Program up to 512K byte flash.
SKU: n/a -
USB Interface Module
USB Blaster ALTERA CPLD/FPGA Programmer
SKU:- Stably support SignalTap II embedded logic analyzer function, no mistake while crawling data.
- Fully support all Altera products such as CPLD: MAX3000, MAX7000, MAX9000 and MAXII.
- FPGA: Stratix, StratixII, StratxIII, Cyclone, CycloneII, CycloneIII, ACEX1K, APEX20K and FLEX10K etc.
- Active serial configuration device: EPCS1, EPCS4, EPCS16, EPCS64 etc.
- Enhanced configuration devices: EPC1, EPC4.
- Supports 3 download mode: AS, PS and JTAG.
SKU: n/a -
PIC Programmer
PIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
PIC ProgrammerPIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
SKU:- Support the most popular programming PIC chips, read, encryption and other features!
- No external power supply, communication, and power is only a USB cable to print complete, without any cable.
- PICSTARTPLUS much faster rate than programming.
- Can easily read the contents of the chip program area.
- Automatic programming verification.
- Comprehensive information prompts, allowing users to understand the working state.
SKU: n/a -
PIC Programmer
PIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
PIC ProgrammerPIC K150 USB Automatic Develop Microcontroller Programmer with ICSP Cable (Body width: 4 mm)
SKU:- Support the most popular programming PIC chips, read, encryption and other features!
- No external power supply, communication, and power is only a USB cable to print complete, without any cable.
- PICSTARTPLUS much faster rate than programming.
- Can easily read the contents of the chip program area.
- Automatic programming verification.
- Comprehensive information prompts, allowing users to understand the working state.
SKU: n/a -
-
(ESC) Drone Speed Controller
New ESC USB Linker Programmer For Simonk BLHeli Firmware SN/BL/16A/20A/30A/40A
(ESC) Drone Speed ControllerNew ESC USB Linker Programmer For Simonk BLHeli Firmware SN/BL/16A/20A/30A/40A
SKU:- Direct plug design,
- Works with most USB port and USB extension cable
- Â Low power consumption design
- Onboard 2×3 Pin AVR ISP port
- Â 3pin servo connector can be used as servo or C2 connection
- Supports SIMONK and BLHELI ESC, KKflashtool compatible
- KKflashtool and RapidFlash compatible
Â
Â
SKU: n/a -
PIC Programmer
ICSP Programmer Socket – UIC-S
SKU:-
No external power needed
-
Power Indicator LED on board
-
Fit perfectly with UIC00A and UIC00B
-
Support 18-pin, 28-pin, and 40-pin 8-bit PIC microcontroller.
-
Selector to program 18-pin or 28-pin&40-pin PIC
-
Come with 40-pin ZIF socket for ease of plug and unplug of PIC
SKU: n/a -
-
PIC Programmer
ICSP Universal Socket
SKU:To ease user, Cytron has created this UIC-A so that user can use any programmer regardless of the development board. For example, a development board which uses PICkit2’s socket standard, which is 6-way header pins can be programmed with UIC000B by using the UIC-A!
SKU: n/a -
USB Interface Module
USB PIC Programmer – UP00B
SKU:- USB powered, no extra power needed to load program
- Two ZIF sockets (20 pins and 40 pins) to ease the program loading process
- Support most 8pin, 18pin, 28pin and 40pin PDIP 8 bit PIC MCU
- Support Windows XP, Vista, 7 (32 and 64-bits)
- Support Intel and AMD based system
- Support Laptop and desktop PC
SKU: n/a