LED
Showing all 31 results
-
Best Prices, LED Module
CJMCU-123 WS2812 RGB LED Breakout Module
SKU:- Supply Voltage: 5V.
- Viewing angle: 120 degrees
- The color of the light was highly consistent
- Full-color module, Full-color soft lights a lamp strip.
- Built-in electric reset circuit and power lost reset circuit.
- Each pixel of the three primary colors can achieve 256 brightness levels, or 16M colors full-color display, and scan frequency not less than 400Hz/s.
SKU: n/a -
-
-
-
RGB LED Strips and Drivers
1M WS2812B 5V Addressable RGB Non-Waterproof LED Strip Light 60LED’s/Mtr.
SKU:- Installation surface must be smooth, clean and dry
- The part of LED components cannot be fixed on the surface of the sharp edges
- The strip should not be collided or crushed
- The strip can be cut following the cutting lines
- 24-bit color control (8-bit PWM per channel); 16.8 million colors per pixel
- The one-wire digital control interface
- Each RGB LED draws approximately 50Â mA at 5Â V with red, green, and blue at full brightness
SKU: n/a -
RGB LED Strips and Drivers
16Bit WS2812B 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
RGB LED Strips and Drivers16Bit WS2812B 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
SKU:- Outer Diameter: 68 mm.
- Supply Voltage: DC 4-7V.
- LED driver chip:Â WS2812B
- Communication interface: single wire communication.
- Send data at speeds of 800Kbps.
- The color of the light was highly consistent
- Full-color module, Full-color soft lights a lamp strip.
SKU: n/a -
RGB LED Strips and Drivers
8 Bit WS2812 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
RGB LED Strips and Drivers8 Bit WS2812 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
SKU:- Outer Diameter: 32 mm.
- Supply Voltage: DC 4-7V.
- LED Driver IC:Â WS2812
- Communication interface: single wire communication.
- Send data at speeds of 800Kbps.
- The color of the light was highly consistent
- Full-color module, Full-color soft lights a lamp strip.
SKU: n/a -
RGB LED Strips and Drivers
WS2812B RGB Addressable LED Module-10Pcs
SKU:- Supply Voltage: 5V.
- Viewing angle: 120 degrees
- Red: (620-630nm) @ 550-700mcd
- Green: (515-530nm) @ 1100-1400mcd
- Blue: (465-475nm) @ 200-400mcd
- Built-in electric reset circuit and power lost reset circuit.
- Each pixel of the three primary colors can achieve 256 brightness levels, or 16M colors full-color display, and scan frequency not less than 400Hz/s.
SKU: n/a -
RGB LED Strips and Drivers
24 Bit WS2812 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
RGB LED Strips and Drivers24 Bit WS2812 5050 RGB LED Built-in Full Color Driving Lights Circular Development Board
SKU:- Outer Diameter: 86 mm.
- Supply Voltage: DC 4-7V.
- Communication interface: single wire communication.
- Send data at speeds of 800Kbps.
- The color of the light was highly consistent
- Full-color module, Full-color soft lights a lamp strip.
SKU: n/a -
-
Wearable Electronic
LilyPad LED White Color
SKU:LilyPad is a wearable e-textile technology. Each LilyPad piece was creatively designed with large sew tabs to allow them to be sewn into the fabric. Various input, output, power and sensor boards are available. They’re even washable (with special care)!
SKU: n/a -
Wearable Electronic
LilyPad LED Blue Color
SKU:LilyPad is a wearable e-textile technology. Each LilyPad piece was creatively designed with large sew tabs to allow them to be sewn into the fabric. Various input, output, power and sensor boards are available. They’re even washable (with special care)!
SKU: n/a -
Wearable Electronic
LilyPad LED Green Color
SKU:LilyPad is a wearable e-textile technology. Each LilyPad piece was creatively designed with large sew tabs to allow them to be sewn into the fabric. Various input, output, power and sensor boards are available. They’re even washable (with special care)!
SKU: n/a -
RGB LED Strips and Drivers
WS2812B 5V Addressable RGB IP67 Waterproof LED Strip – 5m
SKU:- 5m total length.
- 60 LEDs/m.
- 24-bit color control (8-bit PWM per channel).
- 16.8 million colors per pixel.
- The one-wire digital control interface.
- Each RGB LED draws approximately 50 mA at 5 V with red, green, and blue at full brightness.
- Waterproof.
SKU: n/a -
Wearable Electronic
LilyPad Tri-Color LED RGB Module for Arduino
SKU:LilyPad is a wearable e-textile technology. Each LilyPad was creatively designed to have large connecting pads to allow them to be sewn into clothing. Various input, output, power, and sensor boards are available. They’re even washable!
SKU: n/a -
LED Module
Full Color LED Module / RGB V2 light water for arduino
SKU:- Good PRINT PACK design, very beautiful.
- 8 world of the three primary colors (red-green-blue) LED color, scanning control mode.
- Applicable for various platforms, such as 51 / AVR / AVR / ARM / for Arduino All kinds of platforms.
SKU: n/a -
Electronic Switches/Keypads Modules
DS9092+ iButton Probe with LED Light
SKU:- Simple, low-cost metal stampings form a read/write probe for the iButton family
- Probe guides the entry of the iButton
- iButton slides over the surface to self-clean contacts
- Accessible shallow probe cavity simplifies removal of debris such as mud
- Flexible design supports panel-mount or hand-grip mount with optional tactile feedback
SKU: n/a -
-
BBC MicroBit Board
Micro bit GO Kit by BBC
SKU:Get creative, get connected & get coding with the BBC micro:bit go. A complete set containing all the parts and inspirational ideas to get started with the BBC micro:bit. Each BBC micro:bit go contains 1x BBC micro:bit, USB cable, battery holder & 2x AAA batteries along with a Quick Start Guide featuring 4 fun ideas all in a retail ready pack.
SKU: n/a -