Welcome to SmartElex, where we proudly design and manufacture smart electronic hardware in India.
SmartElex provides great quality products at reasonable prices with a 1-year warranty. Whereas other generic electronic hardware is cheap and low in quality, as well as good quality hardware is expensive. We believe in empowering ideas through our products.
SmartElex
Showing 1–48 of 144 results
-
SmartElex Bluetooth + WiFi Modules
SmartElex ESP32 38Pin Development Kit WiFi+Bluetooth Ultra-Low Power Consumption Dual Core – 1 PCS
SmartElex Bluetooth + WiFi ModulesSmartElex ESP32 38Pin Development Kit WiFi+Bluetooth Ultra-Low Power Consumption Dual Core – 1 PCS
SKU: R1505411. 2.4GHz Dual-Mode WiFi + Bluetooth Development Board, 38PIN
2. Ultra-Low power consumption works perfectly with the IDE
3. Support LWIP protocol, Freertos
4. Support Three Modes: AP, STA, and AP+STA
5. ESP 32 is safe, reliable, and scalable to a variety of applicationsSKU: R150541 -
-
-
-
-
Electronics Components on Sale, SmartElex Smart Motor Drivers
SmartElex 15D Smart Motor Driver (Powered By Raspberry Pi)
-26%
Electronics Components on Sale, SmartElex Smart Motor DriversSmartElex 15D Smart Motor Driver (Powered By Raspberry Pi)
SKU: 1734772- Support motor voltage from 7V to 22V.
- Onboard Low, Internal resistance MOSFETs are switched at 16 KHz frequency.
- Overcurrent and Thermal protection.
- Multiple input modes: RC, Analog, PWM, Serial Packetized.
- On-board push buttons for test and manual operation.
- Type-C USB for SERIAL Mode
SKU: 1734772 -
Electronics Components on Sale, SmartElex Smart Motor Drivers
SmartElex 30D Smart Motor Driver (Powered by Raspberry Pi)
-35%
Electronics Components on Sale, SmartElex Smart Motor DriversSmartElex 30D Smart Motor Driver (Powered by Raspberry Pi)
SKU: 1734773- Supplying 30 amps continuously with peak currents up to 85 amps (2 Sec) per channel.
- Support motor voltage from 7V to 28V.
- Onboard Low Internal resistance MOSFETs are switched at 16KHz frequency.
- Overcurrent protection and indication.
- Thermal protection.
- Type-C USB for SERIAL Mode
SKU: 1734773 -
SmartElex Level Shifter Modules
SmartElex Logic Level Converter – Bi-Directional
SKU: R183234- Bi-Directional Conversion: 5V to 3.3V and 3.3V to 5V.
- Wide Voltage Range: Supports 1.8V, 2.8V, 3.3V, and 5V devices.
- Simple Setup: Easy connections with HV, LV, and GND pins.
- Four Pins Each Side: Two inputs and two outputs for flexibility.
- Compact Design: Space-efficient for easy integration.
- Reliable Performance: Safe and effective signal translation.
SKU: R183234 -
SmartElex Development Board
SmartElex AT89S52 Development Board with LCD
SKU: 464732- Onboard 5V regulator (78M05) circuit.
- On-Board power supply on-off switch
- On-Board DC motor Driver L298P
- On-Board 4×4 Matrix Keypad.
- On-Board 4 bit 16×2 LCD Display.
- 0592MHz crystal.
- Port extensions for all ports with detailed pin labelling for easy identification of pins
- Onboard USB TO Serial – CH340 Chip.
- On-board Micro USB USBASP for loading HEX file.
SKU: 464732 -
Electronics Components on Sale, SmartElex Smart Motor Drivers
SmartElex 10D Smart Motor Driver (Powered by Raspberry Pi)
-20%
Electronics Components on Sale, SmartElex Smart Motor DriversSmartElex 10D Smart Motor Driver (Powered by Raspberry Pi)
SKU: 1734771- Onboard 5V 3A Buck Converter.
- Continuous 10A maximum current without Heatsink
- Two brushed DC motor Bidirectional control.
- Current limiting at 35A.
- PWM and direction-controlled driving of four externally powered NMOS transistors
- Type-C USB for SERIAL Mode
SKU: 1734771 -
SmartElex Connector Modules
SmartElex USB-C Breakout – Horizontal Module
SKU: R177461- USB-C connector for easy integration into projects without soldering tiny SMD pads.
- Supplies up to three times the power of previous USB iterations.
- Reversible design eliminates the issue of plugging in a USB cable incorrectly.
- Breaks out VBUS, GND, CC1, CC2, D+, and D- pins into a 0.1″ pitch header.
- Provides nominal 1.5A of power, with potential for up to 3A depending on the upstream device.
SKU: R177461 -
Brushed / Brushless DC motor Driver
SmartElex Wireless Remote Control with NRF24L01+PA+LNA SMA Antenna
Brushed / Brushless DC motor DriverSmartElex Wireless Remote Control with NRF24L01+PA+LNA SMA Antenna
SKU: 664890- It uses 2.4GHz global open ISM band, with license-free.
- Operating Range: 1Km
- Antenna Gain (peak): 2Dbi.
- Transmit power is greater than +20 dBm.
- Support six-channel data reception.
SKU: 664890 -
Battery Chargers, Battery Charging Boards
SmartElex 1S 18650 Li-ion Battery Charger/Discharger
SKU: 611923- Input Voltage: 4.5V ~ 5.5V.
- Input Interface: 5VDC Micro USB and DC JACK input.
- On-board Battery compatible: – 18650 Li-ion cell.
- Charge Current: up to 1A.
- Over-voltage detection: 4.2V.
- Under-voltage detection: 2.8V.
- Output Interface: – 2 Pin Connector with a properly marked positive and negative signs on PCB.
- LED indicator: Input Power status/ Charging /Charge complete / Battery detects / under-voltage.
SKU: 611923 -
-
SmartElex Connector Modules
SmartElex USB Type A Female Breakout Module
SKU: R177463- Connector Type: Female USB Type A
- Header Pitch: 0.1″ (2.54mm)
- Board Dimensions: Approximately 15mm x 12mm
- Voltage Rating: 5V (standard USB voltage)
- Current Rating: Up to 1.8A (depending on component quality)
SKU: R177463 -
SmartElex Connector Modules
SmartElex MicroB USB Breakout Module
SKU: R177462- Connector Type: Micro-B USB
- Pinout: VCC, GND, ID, D-, D+
- Header Pitch: 0.1″ (2.54mm)
- Board Dimensions: Approximately 15mm x 12mm (size may vary slightly depending on manufacturer)
- Voltage Rating: 5V (USB standard)
- Current Rating: Typically up to 1.8A (USB standard), depending on the quality of the
SKU: R177462 -
-
-
SmartElex Movement Sensors
SmartElex 6 Degrees of Freedom Breakout – LSM6DSO
SKU: R101054- Accelerometer measurement range: ±2/±4/±8/±16 g full scale
- Gyro measurement range: ±125/±250/±500/±1000/±2000 dps full scale
- Embedded temperature sensor: 16-bit resolution
- Operating voltage range: 1.71V to 3.6V / Typically 3.3V
SKU: R101054
