Generic
Showing 385–432 of 7162 results
-
-
LASER Module
SYD1230 12mm 5mw cross-line Laser Module – Red
SKU: 30650- Laser Output Type: Red Cross-Line Laser
- Dimensions: Diameter: 12mm, Lenght: 35mm.
- Weight: 15 gm.
- Wavelength: 650nm.
- Voltage: 3~6V.
- Output Power: Min 2.5mW, Typical 3.0mW, Max 5.0mW.
- Working current: Min 10mA, Typical 20mA, Max 25mA.
- Focus point Intensity can be adjusted with help of lens ring head.
SKU: 30650 -
-
-
Potentiometer Module
DC 3-5V X9C103S Digital Potentiometer Board Module for Arduino
SKU: 43886- Supply voltage: 3V-5V
- Chip: X9C103S
- Dimensions : 28 x 14 x 4 (LxWxH) mm.
- 10K span potentiometer.
- Potentiometer center tap between the 0-10k slide in total 100 (potentiometer wiper typical impedance 40 ohms)
SKU: 43886 -
-
-
-
-
USB Interface Module
SD Card Reading Writing Module for Arduino
SKU: 44160- All SD SPI pins output, MOSI, SCK, MISO, and CS.
- Support 5V/3.3V input.
- This module can handle 2GB SD cards.
- Size:4.7 x 3.1 cm.
- LED indicator.
- SD Card Holder.
- Onboard 3.3V regulator (AMS1117-3.3) for +5v to 3.3V generation. 3.3V is also available as output.
SKU: 44160 -
-
Motor Mounting Brackets
Servo Mount Brackets For MG995 MG996 Servo Motor
SKU: 975837- Supported Motors: 10kg-cm servos (such as MG995, MG996)
- No of Axis: 2 axis
- Weight : 51.2gms
- No of Metallic Pieces: 2
- This product is made of high-quality materials and is durable.
- Various sensors can be installed to complete a variety of novel interactive works through the servo controller.
- It is convenient to install the camera, which can realize image monitoring and image recognition and tracking.
SKU: 975837 -
-
Best Prices, Other ESP WIFI Modules
ESP32-WROOM-32E 4M 32Mbit Flash WiFi Bluetooth Module
SKU: 975749- ESP32-D0WD-V3 embedded, Xtensa dual-core
- 32-bit LX6 microprocessor, up to 240 MHz
- 448 KB ROM for booting and core functions
- 520 KB SRAM for data and instructions
- 16 KB SRAM in RTC
- WiFi: 802.11b/g/n
- Bit rate: 802.11n up to 150 Mbps
SKU: 975749 -
Breakout Board
PAM 8610 Digital Stereo Class-D Amplifier Board 2x15W Output
SKU: 43918- Dual-Channel Stereo Output
- Run-on 7V to 15V power Supply
- 32 Steps DC volume control has a +32dB to -75dB range.
- 40 pin QFN 6 x 6 mm package.
- Much higher efficiency in terms of cost and performance than competitors’ ICs
SKU: 43918 -
-
USB Interface Module
USB To Serial Adapter Module USB TO TTL RS232 Arduino Cable With CTS RTS
SKU: 43433- The TTL-232R cables are a family of USB to TTL serial UART converter cables incorporating FTD’s.
- UART interface IC device which handles all the USB signaling and protocols. The cables provide a fast, simple way to connect.
- Devices with a TTL level serial interface to USB.
- Each TTL-232R cable contains a small internal electronic circuit board, utilizing the FT232R, which is encapsulated into the USB.
- the connector end of the cable. The other end of the cable comes with a selection of different connectors supporting various applications.
- The USB side of the cable is USB powered and USB 2.0 full speed compatible.
- Each cable is 1.0m long and supports a data transfer rate up to 3 M baud.
SKU: 43433 -
-
-
-
-
Power Adapter and Cable, Power Cables and Accessories
AC 250V 15A IEC320 C14 Male Power Cord Inlet Socket with Fuse Holder
Power Adapter and Cable, Power Cables and AccessoriesAC 250V 15A IEC320 C14 Male Power Cord Inlet Socket with Fuse Holder
SKU: 975702- Plug Type : 3 Pin IEC320 C14
- Terminal Pin Size: 4.8×0.8mm
- Hole Center Distance: 36 mm
- Voltage/ Current : 15A, 250V AC
- Hole in Top Face Diameter: 3.5mm
- Fuse Ampere(Presupposed): 15A
SKU: 975702 -
-
Other Metal Geared Motors
100RPM 12V Low Noise Dc Motor With Metal Gears – Grade A
SKU: 1137796- The metal gears have better wear and tear properties.
- The gearbox is sealed and lubricated with lithium grease and requires no maintenance.
- Although the motor gives 100 RPM at 12V, the motor runs smoothly from 4V to 12V and gives a wide range of RPM, and torque.
- The shaft has a hole for better coupling.
- Operating Voltage(V): 12
- Rated Torque(kg-cm): 2.9
- Stall Torque(kg-cm): 11.4
SKU: 1137796 -
Raspberry Pi Accessories
1/4 Cmos 640X480 USB Camera with Collapsible Cable for Raspberry Pi
SKU: 216740- Supports 300k pixels, a maximum resolution of 640×480, and VGA/ YUY2 packed formats
- Dimension: 40mm × 15mm × 30mm; designed for Raspberry Pi and PC
- With a retractable USB cable, convenient to store
- Applies USB 2.0 High-speed Sensor, plug-and-play, no driver installation
- High definition and true colour images.
SKU: 216740 -
Relay Modules
5V 1 Channel Without Light Coupling Relay
SKU: 618455- The 8550 transistor drive, driveability.
- A fixed bolt holes for easy installation.
- It has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
- Relay control interface by single-chip IO.
- Low-level suction close, high-level release.
- Easy to use, simple 3 line structure.
SKU: 618455 -
-
PCT Wire Connectors
LT-933(SPL-93) Stationary Type Quick Connection Terminal
SKU: 1121341- Rated Voltage (V):450
- Rated Current(A):32
- Body Material: Modified Nylon (PA66)
- Contact Material: Stainless Steel
- No. of Contact Points:9:3
- Rated Power (W):4 KW
- Allowed Wire Size (AWG):28 ~ 12
- Color:Grey+Orange+Blue+Yellow
SKU: 1121341 -
Soldering Tools
TE-801 Multi-function LED Magnifier PCB Soldering iron Stand Holder Table Magnifying glass 35X 12X w/ 2-LED Light
Soldering ToolsTE-801 Multi-function LED Magnifier PCB Soldering iron Stand Holder Table Magnifying glass 35X 12X w/ 2-LED Light
SKU: 17940- A useful Aid for soldering work or model makers
- Battery required for light: 3 x AAA
- Adjustable crocodile holding clamps
- The bottom battery compartment is furnished with steel plate which can enhance stability
- Ideal when a third hand is needed
- With two LED lighting, this model can work very well in the dark environment
SKU: 17940 -
-
