Generic
Showing 145–192 of 6509 results
-
PCB Adapter
TQFP32/44/64/80/100 to DIP PCB Board Converter Adapter-1Pcs.
SKU:- High-quality PCB FR4 Grade with FPT Certified.
- QFP/TQFP/LQFP/FQFP 32/44/64/80/100Â pin switch over DIP double-sided pinboard
- Double-sided FR-4PCB, unique design makes the board compatible with more models of IC packages QFP
SKU: n/a -
-
IMU, Accelerometer, Magnetometer & Gyroscope
ADXL345 Tripple Axis Accelerometer Board
SKU:- Supply Voltage:Â 3.3 V/ 5V.
- Interface Type: I²C, SPI.
- Sensing Range: ±2g, ±4g, ±8g, ±16g.
- Sensitivity:
- X: 28.6 LSB/g.
- Y: 31.2 LSB/g.
- Z: 34.5 LSB/g.
- Ultra Low Power: 40µA in measurement mode, 0.1µA in standby@ 2.5V.
- Free-Fall Detection.
- Tap/Double Tap Detection.
SKU: n/a -
DIY Hobby Project Parts
50cm Long Alligator Clips, Electrical DIY Test Leads 5pcs, for Micro:bit
SKU:- Colour: Red, Green, Yellow, White, and Black, etc.
- Cable length: 40 cm.
- Net weight: 50 gm.
- They are very useful for connecting components to wires.
- It is insulation covered clips connected to the wire from both ends.
SKU: n/a -
-
USB Interface Module
TJA1050 CAN Controller Bus Driver Interface Module
SKU:- Onboard TJA1050 CAN controller interface chip
- Chip commonly used pin has led, convenient connection to use
- Pin 5 v to the power supply
- PCB board size: 22 (mm) x11.5 (mm)
- Fully compatible with the ISO 11898 standard
- High speed (up to 1 Mbaud)
SKU: n/a -
-
Raspberry Pi Accessories
Raspberry Pi 4 Aluminium Heat Sink – 4 Set ( Size: 14 x 14 x 6, 14 x 9 x4 & 2 7 x 7 x 6)
Raspberry Pi AccessoriesRaspberry Pi 4 Aluminium Heat Sink – 4 Set ( Size: 14 x 14 x 6, 14 x 9 x4 & 2 7 x 7 x 6)
SKU:- Reduces the risk of hardware failure due to overheating
- Low profile, will fit into most cases.
- Simple, Passive cooling. No need for noisy fans.
- Perfectly sized for the RPi’s CPU
SKU: n/a -
Best Prices, Boards Compatible with Arduino
Mega2560 Pro ATMEGA2560-16AU USB CH340G Development Board
Best Prices, Boards Compatible with ArduinoMega2560 Pro ATMEGA2560-16AU USB CH340G Development Board
SKU:- The board is compatible with Mega 2560.
- Â excellent solution for developing projects based on ATmega2560.
- The board can be powered directly through the Micro USB connector
- The maximum output current upon 5V is around 800mA, while on the 3.3V it is about 800mA.
SKU: n/a -
TowerPro and Other Servo Motors
MG90S 9g Servo Metal Gear – 360 Degree
SKU:- Dimensions: 23 x 12.2 x 29mm
- Operating Speed (4.8V no load): 0.11sec / 60 degrees
- Operating Speed (6.0V no load): 0.10sec / 60 degrees
- Stall Torque (4.8V): 2.0 kg/cm
- Stall Torque (6.0V): 2.5 kg/cm
- Temperature Range: 0 to 55 degree C
- Rotation angle: 360 °
- Dead Band Width: 15 Microsecond
- Operation Voltage: 4.8 – 6.0 Volts
- Recommend Model: Mini Car / Mini Ship /Helicopter & Airplane
SKU: n/a -
Drivers & Interfaces IC
LM35 TO-92-3 Board Mount Temperature Sensors
SKU:- Calibrated directly in Degree Celsius (Centigrade)
- Linear at 10.0 mV/°C scale factor
- 0.5°C accuracy guarantee-able (at a25°C)
- Suitable for remote applications
- Low cost due to wafer-level trimming
- Operates from 4 to 30 volts
- Less than 60 mA current drain
- Low self-heating, 0.08°C in still air
- Non-linearity only 0.25°C typical
SKU: n/a -
-
-
-
Relay Modules
5V 4 Channel Relay Module
SKU:- 5V 4-Channel Relay interface board and each one needs 15-20mA Driver Current.
- Equipped with high-current relay, AC250V 10A; DC30V 10A.
- Standard interface that can be controlled directly by microcontroller (for Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic).
- Indication LED’s for Relay output status.
SKU: n/a -
Relay Modules
1 Channel Relay Module, 30A with Optocoupler, Isolation 12V Supports, High and Low Triger
Relay Modules1 Channel Relay Module, 30A with Optocoupler, Isolation 12V Supports, High and Low Triger
SKU:- Channel: 1 channel
- Relay Voltage: 12V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
SKU: n/a -
-
-
Boards Compatible with Arduino
UNO R3 CH340G ATMega328P compatible with arduino + Cable
SKU:- A basic Arduino Kit including everything to get started.
- It includes a quality proven Arduino Cable.
- Microcontroller ATmega328 (SMD) – Interface CH340G
- Operating Voltage: 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins 14 (of which 6 provide PWM output)
- Analog Input Pins: 6
SKU: n/a -
-
-
-
RTC Module
DS1302 RTC Real Time Clock Module with Battery
SKU:The DS1302 trickle-charge timekeeping chip module with battery backup contains a real-time clock/calendar and 31 bytes of static RAM. It communicates with a microprocessor via a simple serial interface. The real-time clock/calendar provides seconds,minutes, hours, day, date, month, and year information.
SKU: n/a -
-
-
Other Measuring Instrument
Peacefair PZEM-004T AC Multi-function Electric Energy Metering Power Monitor
Other Measuring InstrumentPeacefair PZEM-004T AC Multi-function Electric Energy Metering Power Monitor
SKU:- Brand: Peacefair
- Model:Â PZEM-004T
- Operating Voltage: 80-260VAC
- Test Voltage: 80-260VAC
- Rated Current: 100A
- Rated power: 100A / 22000W
- Operating frequency: 45-65Hz
- Measurement accuracy: 1.0
SKU: n/a -
-
-