Generic
Showing 1537–1584 of 7207 results
-
Other ESP WIFI Modules
ESP32-WROOM-32D 4M 32Mbit Flash WiFi Bluetooth Module
SKU: 975746- Xtensa 32-bit LX6 microprocessors
- 1 Kbit of EFUSE, 256 bits MAC
- WiFi: 802.11 b/g/n/d/e/i/k/r (802.11n up to 150 Mbps)
- Bluetooth v4.2 BR/EDR and BLE specification
- Wi-Fi mode Station/softAP/SoftAP+station/P2P
- Operating voltate: 2.2-3.6V
SKU: 975746 -
-
Drone Gimbal and Accessories
BGC v3.15 MOS Large Current 2-axis Brushless Gimbal Controller Driver
SKU: 45627- Stabilization Axes: 2
- Supply Voltage: 8V to 18V (3s-4s LiPo)
- Maximum DC current to each motor 2.8A
- Supported sensors: MPU6050
- Overcurrent protection: Yes
- Overheat protection: Yes
- Undervoltage protection: Yes
- Reverse polarity protection: Yes
- Support 2-8 series gimbal motor
- Peak current 10A
SKU: 45627 -
6S Li-ion BMS
6S 40A 18650 Lithium Battery Protection Board
SKU: 618355- Maximum discharge current: 40A
- Instantaneous discharge current: 70A
- Charging voltage: 25.5V
- Maximum charging current: 40A
- Overcharge detection voltage: 4.25±0.025V
- Overcharge protection delay: 1.0±0.5S
- Overcharge release voltage: 4.15±0.05V
- Battery balance detection voltage: 4.125±0.025V
- Battery balance release voltage: 4.125±0.05V
- Battery balance current: 41±5mA
- Working current: ≤40uA
SKU: 618355 -
-
Vibration/Tilt Sensor and Modules
801S Vibration Shock Sensor Module
SKU: 43743- Has a signal output instruction
- When the output valid signal is high, the light goes out
- The sensitivity is adjustable (fine-tuning)
- The wide detection range of vibration, no direction
- With mounting holes, firmware installation is flexible and convenient.
SKU: 43743 -
-
-
Brushed / Brushless DC motor Driver
12V 24V 36V 40A PWM DC Motor Speed Controller Forward Reverse Adjustable Knob Switch with Case
Brushed / Brushless DC motor Driver12V 24V 36V 40A PWM DC Motor Speed Controller Forward Reverse Adjustable Knob Switch with Case
SKU: 1307994- Input voltage: DC12 to 36V (equal to the rated voltage of the motor)
- Output voltage: linear under load
- Maximum current: 50A
- Continuous current: 40A
- Support motor: DC brush motor
SKU: 1307994 -
Multi Layer Ceramic Capacitors (MLCC)
2.2nF 1206 Surface Mount Multilayer Ceramic Capacitor (Pack of 30)
Multi Layer Ceramic Capacitors (MLCC)2.2nF 1206 Surface Mount Multilayer Ceramic Capacitor (Pack of 30)
SKU: 596595- Capacitance: 2.2 nF
- Voltage: 50V
- Mounting type: SMD/SMT
- Operating temperature: -55ºC to 125ºC
- Supplied in tape on reel
- Nickel-barrier end termination
- RoHS compliant
- Halogen Free compliant
SKU: 596595 -
Metal Push Button Switch
12mm 12V Ring Light Self-Lock Non-Momentary Metal Switch-Yellow Light
SKU: 130233- Stainless steel material for long-term use
- Inbuilt Colorful Ring illumination LED
- Available in Various LED Color
- Bright daylight LEDs
- Single pole push to make and Push to break Function
- Front and rear panel seal to IP67 & TVS protection
- Rubber ring and hexagon nut to fix, Waterproof and Dustproof
SKU: 130233 -
-
-
-
-
-
Audio Amplifier Module
TDA7297 12V Stereo Noiseless Audio Power Amplifier Module with 2 x 15W Output
SKU: 815874- Can be accessed by two 4-8Ω 10-50W speakers
- A large volume of small size
- High signal to noise ratio
- An upgraded version of the radiator, wider and thicker, better cooling effect
- Fit for Bookshelf speakers, CRT televisions, radios, and other small amplifiers
SKU: 815874 -
-
-
-
Aluminium Electrolytic Capacitors
2200uF/35V – Electrolytic Capacitor, ± 20%, Radial Leaded, 2000 hours @ 105°C, Polar
Aluminium Electrolytic Capacitors2200uF/35V – Electrolytic Capacitor, ± 20%, Radial Leaded, 2000 hours @ 105°C, Polar
SKU: 1532798- 2200uF/35V electrolytic capacitor.
- Radial leaded design.
- Tolerance of ± 20%.
- Operating temperature up to 105°C.
- Polarized component.
- Long lifespan of 2000 hours.
SKU: 1532798 -
Battery Pack Accessories & Holders
1 x 18650 Battery Holder with, 18.4MM Bore Diameter – pack of 4
SKU: 1121229- Model: 18650 radiating battery spacer.
- Material: ABS/PC (Remarkable Flame Retardant Plastic).
- Bore Diameter: 18.5mm
- Combined them into many different sizes and shapes of the battery pack.
- Application: Design for Radiating Complex Battery Packs. Safe and Stable, Perfect Build for eBike!
SKU: 1121229 -
-
Battery Pack Accessories & Holders
4 X 4 32650 Battery Holder
SKU: 1676137- Model: 32650 radiating battery spacer.
- Material: ABS/PC (Remarkable Flame Retardant Plastic).
- Bore Diameter: 32.35MM
- Combined them into many different sizes and shapes of the battery pack.
- Application: Design for Radiating Complex Battery Packs. Safe and Stable, Perfect Build for eBike!
SKU: 1676137 -
