Generic
Showing 1489–1536 of 6509 results
-
Thermistor
100k Ohm NTC Thermistor (Pack of 5)
SKU:- Temperature Coefficient Type: NTC
- Thermal Time Constant: 10s
- Resistance 100kΩ
- Tolerance: ±1%
- Maximum Power Rating: 75mW
- Maximum Operating Temperature: +150°C
- Minimum Operating Temperature: -80°C
- Dimensions(dia.): 2 mm
- Length: 30mm
- Application: Compensation, Control, Measurement, etc.
SKU: n/a -
-
-
-
Breakout Board
D1 Double Sided Breakout PCB Proto Board Shield with Berg Pins
SKU:- The hole plate is a universally designed circuit board that is a good choice for people interested in soldering.
- Compared to professional PCB printed circuit boards, hole boards are low-cost and are favored by amateurs.
- Easy to use.
- Flexible expansion
SKU: n/a -
RGB LED Strips and Drivers
5M Light Dance Party Decor Light Neon LED Lamp Flexible Rope Tube Waterproof LED Strip – Only EL Wire -WHITE
RGB LED Strips and Drivers5M Light Dance Party Decor Light Neon LED Lamp Flexible Rope Tube Waterproof LED Strip – Only EL Wire -WHITE
SKU:- Input Voltage:12 V
- Can offer 360 degrees of illumination
- Energy-saving, long lifetime
- Wire diameter:Â 2mm
- EL light length: 5M
- Lifetime: >12,000 hours
- Color: White
SKU: n/a -
Audio Amplifier Module
TDA7297 12V Stereo Noiseless Audio Power Amplifier Module with 2 x 15W Output
SKU:- Can be accessed by two 4-8Ω 10-50W speakers
- A large volume of small size
- High signal to noise ratio
- An upgraded version of the radiator, wider and thicker, better cooling effect
- Fit for Bookshelf speakers, CRT televisions, radios, and other small amplifiers
SKU: n/a -
-
Buck Converter
AMS1117-5.0 LDO 800MA DC 5V to 3.3V Step-Down Power Supply Module
SKU:- Output Voltage: 3.3V to 5V
- Output Current: 800mA
- Onboard AMS1117 chip.
- Onboard power indicator to indicate power is turned on: Red LED.
- Output voltage interface, connection to facilitate the experimental.
- Small Compact Size, 3Pin Type, Breadboard Friendly.
SKU: n/a -
-
-
-
-
-
Battery Pack Accessories & Holders
4 X 4 32650 Battery Holder
SKU:- Model: 32650 radiating battery spacer.
- Material: ABS/PC (Remarkable Flame Retardant Plastic).
- Bore Diameter: 32.35MM
- Combined them into many different sizes and shapes of the battery pack.
- Application: Design for Radiating Complex Battery Packs. Safe and Stable, Perfect Build for eBike!
SKU: n/a -
Relay Modules
2 Channel Relay Module 30A with Optocoupler Isolation 5V Supports High and Low Triger
SKU:- Supply Voltage: DC 5V
- Quiescent Current: 5mA
- Maximum Operating Current: 190mA
- Trigger Mode: High and low-level trigger
- Load Voltage: DC 30V / AC250
- Load Current: 30A
- Relay Life: more than 100,000 times
SKU: n/a -
-
-
Linear voltage regulator IC
IC-LM2576S-12/NOPB
SKU:- 3.3-V, 5-V, 12-V, 15-V, and adjustable output versions
- Adjustable version output voltage range,1.23 V to
- 37 V (57 V for HV version) ±4% maximum over line and load conditions
- Specified 3-A output current
- Wide input voltage range: 40 V Up to 60 V for HV version
SKU: n/a -
Water TDS, pH, Flow, Level Sensor
Side Mounted Small Float Level Control Switch Plastic Float Switch 55mm
Water TDS, pH, Flow, Level SensorSide Mounted Small Float Level Control Switch Plastic Float Switch 55mm
SKU:- Rhodium reed switch
- Special handling reed switches in high temperature
- Overall performance and reliable float switch
- Long-lasting life: Up to 100 million times
- Switch Length: 55 mm
- Cable Length: 300 mm
SKU: n/a -
-
-
Solar Panels and Controllers
Solar/Wind energy Charging CC/CV Power Supply Module
SKU:- Module Properties: non-isolated Buck-Boost constant current, constant voltage module (CC-CV) charging module
- Battery charger (including ferroelectric), 4V, 6V, 12V, 14V, 24V battery charging, nickel-cadmium nickel-metal hydride batteries (battery) charger, solar panels, wind generators.
- Solar Panel, Wind generator voltage regulator, Car Power Supply
SKU: n/a -
FPV Antennas and Trans-Receivers
915Mhz 100mW Mini Telemetry Kit
SKU:- Very small size & Lightweight
- MAVLink protocol framing and status reporting
- Interchangeable air and ground modules
- Micro-USB port
- UART interface
- Error correction corrects up to 25% of bit errors
- Configurable through Mission Planner and APM Planner
- The demonstrated range of several kilometers with a small Omni antenna
SKU: n/a -
-
3D Printer Extruder Parts and Fans
PC6-M10 Pneumatic Push in Bowden Extruder for 6mm tube J-Head fitting
3D Printer Extruder Parts and FansPC6-M10 Pneumatic Push in Bowden Extruder for 6mm tube J-Head fitting
SKU:- Inside Diameter: 6mm
- Thread Size: M10
- PTFE Tubing Compatibility: 3mm ID PTFE Tubing (for 1.75mm Filament)
- Materials:Â Nickel Plated Brass
- Release Method:Â Elliptical John Guest Fitting
SKU: n/a