Generic
Showing 721–768 of 6509 results
-
Relay Modules
Red Mushroom Cap LAY37-, 11ZS 1NO 1NC DPST, Emergency Stop Push, Button Switch AC 690V 10A, Switch Equipment Lift, Elevator Latching Self Lock
Relay ModulesRed Mushroom Cap LAY37-, 11ZS 1NO 1NC DPST, Emergency Stop Push, Button Switch AC 690V 10A, Switch Equipment Lift, Elevator Latching Self Lock
SKU:- Rated Insulation Voltage (Ui) : 600V
- Agreed Thermal Current (Ith):10A
- Switch Top Diameter: 39 mm
- Switch Mount Neck Diameter: 23 mm
- Insulation Resistance:≤≥60MΩ
- Contact Resistance: ≤ 25mΩ
- Ambient air temperature: -25°C ~ +40°C
SKU: n/a -
-
-
-
PVC wire
5 Meter UL1007 28AWG PVC Electronic Wire (Black)
SKU:The use of PVC coating blends these wires with special properties such as self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes.
Self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes…
SKU: n/a -
-
-
Sleeves and Drag Chain
Nylon 16mm Expandable Braided Sleeve for Wire Protection-2M Length
SKU:- Great for wrapping power/ground cable.
- Protect cables from wear & high temperature.
- Prolong the service life of the cable.
- Very easy to bend.
- Ultra expandable (150% of original size).
- Gives an attractive look with a clean install.
- Application: Bundle Wiring of Moving Assembles
SKU: n/a -
Current and Voltage Sensor
SCT 013 000 100A Non-Invasive AC Current Sensor Split Core Type Clamp Meter Sensor
Current and Voltage SensorSCT 013 000 100A Non-Invasive AC Current Sensor Split Core Type Clamp Meter Sensor
SKU:- Input Current : 100A
- Frequency: 50HZ-150KHZ
- Opening Size: 13 x 13mm/ 0.5″ x 0.5″(L*W)
- Output Plug 3.5mm
- Dielectric Strength 6000V AC/1min
- Meet UL94-V0 flame retardant properties
SKU: n/a -
USB Interface Module
6Pin FTDI FT232RL FT232 Module For Arduino USB to TTL UART Serial Wire Adapter RS232
USB Interface Module6Pin FTDI FT232RL FT232 Module For Arduino USB to TTL UART Serial Wire Adapter RS232
SKU:- Product: 6Pin FTDI FT232RL FT232 Module For Arduino USB to TTL UART
- Connector type: USB To TTL RS232
- Input Supply voltage: 3.3 ~ 5V
- The cables provide a fast, simple way to connect devices with a TTL level serial interface to USB
SKU: n/a -
-
IR and RF Transmitters and Receivers
HX1838 VS1838 NEC Infrared IR Remote Control Sensor Module For Arduino
IR and RF Transmitters and ReceiversHX1838 VS1838 NEC Infrared IR Remote Control Sensor Module For Arduino
SKU:- Crystal: the oscillation frequency of 455.
- Button: free height is less than 3mm, the force 200-350g, the life of more than 200 000.
- Photo-detector and preamplifier in one package.
- Internal filter for PCM frequency.
- Improved shielding against EMI.
- Don’t forget to add CR2025 Battery to your Cart as this remote does not come with a battery
SKU: n/a -
Stepper Motor Drivers
TMC2208 Stepper Motor Driver Module
SKU:- Voltage range: 3.3-5V
- Maximum current: 1.2A per phase (continuous, with cooling), 2A peak per phase
- Works with 3.3V and 5V signals
- Comes with heatsink for better cooling
- Has StealthChop technology for quieter stepper motors
- Has SpreadCycl technology for smoother movements
SKU: n/a -
Straight Type DC BO Motors
110 RPM Half Metal Gear BO Motor – Straight
SKU:- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication, due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~6
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 110 RPM
- Rated Torque: 1 Kgcm
SKU: n/a -
GPS Modules
25x25x8mm 28db High Gain 5cm Length Built-in Ceramic Active GPS Antenna for NEO-6M NEO-7M NEO-8M
GPS Modules25x25x8mm 28db High Gain 5cm Length Built-in Ceramic Active GPS Antenna for NEO-6M NEO-7M NEO-8M
SKU:- Product: ceramic antenna cable
- Frequency: 1575.42MHz ± 4 MHz
- Antenna gain: 28dB
- Operating temperature: -45 ~ +85
- Polarization: right-hand circular polarization
- Interference suppression: 30dB ± 100MHz
- Weight: 15g
SKU: n/a -
-
Sensor Kits
37 in 1 Sensors Kit compatible with Arduino
SKU:- For beginners who are interested in Arduino
- A complete set of Arduino’s most common and useful electronic components
- Infrared sensor receiving module
- Laser sensor module
- Temperature and humidity sensor module
- Infrared sensor module
- 5v relay module
- Obstacle avoidance sensor module.
SKU: n/a -
-
-
-
Light Dependent Resistors (LDR)
12mm GL12528 Light Sensitive Photoresistor LDR (2Pcs)
SKU:- Diameter: 12 mm
- No. of pins: 2
- Type of mounting: PCB Through Hole
- Maximum Operating Temperature: +70ËšC (Approx.)
- Dark resistance: 1-20MΩ
- Spectral peak: 560nm
- Maximum voltage: 250 VDC
- Maximum wattage: 200 mW
- Light resistance (10 Lux): 10-20 KΩ
- Dark resistance: 2 MΩ
- Resistance illumination: 3
- Response time: 20ms (Rise), 30ms (Down)
SKU: n/a -
-
USB Interface Module
RS422 to TTL Power Supply Converter Board
SKU:- RS422 interface, two-way communication. B Y Z A ultra far transmission 1000 meters
- The module has ESD 15KV protection.
- Onboard to increase the limit of 10 ohms current limiting current protection.
- Module with TVS diode. Anti lightning, peak voltage.
- The module has 120-ohm termination resistors, which can effectively reduce the interference of long-range communication.
SKU: n/a -
-
-
DIY Hobby Project Parts
10Pin Alligator Clips Jumper Wires Crocodile Dupont Line with Male Connector Cable for DIY Connection – 20cm
DIY Hobby Project Parts10Pin Alligator Clips Jumper Wires Crocodile Dupont Line with Male Connector Cable for DIY Connection – 20cm
SKU:- Colour: Red, Blue, Yellow, White, and Black.
- Connector Type: Crocodile Pins and Male Dupont Connector
- Color-coded insulated leads allow you to test circuits without crossing wires or causing shorts with each other.
SKU: n/a -
Shield for Arduino
Data Logger module Logging Shield data Recorder Shield
SKU:- SD card interface works with FAT16 or FAT32 formatted cards. 3.3v level shifter circuitry prevents damage to your SD card.
- Real-time clock (RTC) keeps the time going even when the Arduino is unplugged. The battery backup lasts for years.
- Included libraries and example code for both SD and RTC mean you can get going quickly Prototyping area for soldering connectors, circuitry or sensors.
- The onboard 3.3v regulator is both a reliable reference voltage and also reliably runs SD cards that require a lot of power to run.
- A dedicated and well-designed data logging shield for Arduino.
SKU: n/a