Generic
Showing 577–624 of 7162 results
-
-
Battery Pack Accessories & Holders
CR2032 CR2025 Coin Battery Socket Holder-5Pcs.
SKU: 309532- CR2032 / CR2025 Holder
- Generally used for holding 3v Lithium coin batteries.
- PCB mountable 3v Battery holders which can be soldered directly to PCBs.
- Can be used for experimental boards, toys and small robots etc.
- It is also suitable for 3V Lithium Coin batteries used in Laptops / Computers / Notebooks etc.
SKU: 309532 -
Raspberry Pi Case
Raspberry Pi 4 Black Compact ABS Case
SKU: 620015- Only 3-piece ABS case with access to all Ports on pi 4
- Compatible for All variants of the Raspberry pi 4 Model B
- Easy to assemble and highly durable material
- Slots to route GPIO and CSI ribbon cable
- Cut-out for micro SC card at the bottom panel
- locking screw holes and anti-slip rubber feet at the back.
SKU: 620015 -
Temperature & Humidity Sensor
K-type Thermocouple
SKU: 1320794- Product: K-type Thermocouple
- Tolerance: ± 1.5
- Operating temperature: up to 2000°C
- Thermocouple length: 110cm
- Operating Voltage(VDC): 3 to 5.5
- Internal integrated cold junction compensation circuit
- With a simple three-serial SPI interface
SKU: 1320794 -
-
USB Interface Module
TTL FTDI Transmitter USB For 3.3V/5V Dual power FT232RL MWC Programmer
SKU: 43742- USB Connector type: USB-Mini
- Chip Used: FT232RL
- Output Voltage 5v and 3.3v Indicator LEDs USB Connector
- Automatic detection of data transfer speeds up to 1Mbps
- Data exchange capability with an external interface with UART protocol
- Supports Windows 8, Windows 7, Windows Vista, Windows XP, Linux, Mac OS X, Windows CE 4.2-5.2, Windows CE 6.0
SKU: 43742 -
-
-
Thermistor
10k Ohm NTC Thermistor (Pack of 5)
SKU: 871999- Temperature Coefficient Type: NTC
- Thermal Time Constant: 10s
- Resistance 10kΩ
- Tolerance: ±1%
- Maximum Power Rating: 75mW
- Maximum Operating Temperature: +150°C
- Minimum Operating Temperature: -80°C
- Dimensions(dia.): 2 mm
- Length: 30mm
- Application: Compensation, Control, Measurement, etc.
SKU: 871999 -
Inductive Proximity Sensor
Tube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm Normally Open switch LJ12A3-4-Z/BX
Inductive Proximity SensorTube Type Inductive Proximity Sensor Detection Switch NPN DC6-36V 4mm Normally Open switch LJ12A3-4-Z/BX
SKU: 43801- Model: LJ12A3-4-Z/BX
- Output Type: NPN-NO
- Red LED checks the state of the proximity sensor
- High repeated positioning accuracy
- High switching frequency
- Wide voltage range
- Antivibration, dust, water and oil prevention
- Reverse power protection, short circuit protection, directly connecting with PLC
- Can replace small switches and limit switches
SKU: 43801 -
Drone Parts on Sale, Other Measuring Instrument, Temperature & Humidity Sensor
GM320 Non-Contact Infrared (IR) Handheld Temperature Meter
-27%
Drone Parts on Sale, Other Measuring Instrument, Temperature & Humidity SensorGM320 Non-Contact Infrared (IR) Handheld Temperature Meter
SKU: 45667- Temperature range: -50 to 330°C
- Accuracy: ±1.5% or ±1.5°C
- Resolution: 0.1°C or 0.1°F
- Repeatability: 1% of reading or 1°C
- Supply Voltage: 3V DC (2 x AAA Battery)
SKU: 45667 -
-
Best Prices
MAX31865 PT100-PT1000 RTD Platinum Resistance Temperature Detector Module
SKU: 890201- Integration Lowers System Cost, Simplifies Design
- Efforts, and Reduces Design Cycle Time
- High Accuracy Facilitates Meeting Error Budgets
- 15-Bit ADC Resolution; Nominal Temperature
- Resolution 0.03125NC (Varies Due to RTD Nonlinearity)
- Total Accuracy Over All Operating Conditions:
SKU: 890201 -
24 to 30 AWG
High Quality Ultra Flexible 24AWG Silicone Wire – Red
SKU: R151641- Rated Voltage: 600V
- Rated Temperature: -60°C~+200°C
- Conductor: Tinned Copper
- Conductor construction: 252/0.08
- Color: Red
- Insulation: Silicone Rubber
- Length: 1900 m
- Note : 1 Qty = 1 Meter. The standard roll length is 1900 meters
- Cable length will be continuous as per your ordered Qty.
SKU: R151641 -
Audio Amplifier Module
AVR ISP 10 Pin to 6 Pin Adapter Board
SKU: 31145- Made of high-quality material, practical and durable
- No. of Pinon USBASP side: 10.
- No. of Pinon Device under programming side: 6.
- Connector type on USBASP side: Male.
- Connector type on Device under programming side: Female.
- Header Pin Pitch: 2.54mm (0.1in).
- Pin Numbers Text: Yes on Top and Bottom sides of every pin.
SKU: 31145 -
-
-
Water TDS, pH, Flow, Level Sensor
Square 2M Float Switch For Industry Pump Tank Sensor
SKU: 1150818- Rated current/voltage: 10(8A) 250V ~ 10(4A) 380V
- Protection class: IP68
- Working pressure:0.1MPa
- Operating temperature: 0~75℃
- Electrical life: 1 x 100 000 times
- Mechanical life: 5 x 100 000 times
SKU: 1150818 -
-
Gears
Rack and pinion gear pulley plastic shaft worm gear reducer for robot DIY assorted kit- 34 Kindsrobot kits
GearsRack and pinion gear pulley plastic shaft worm gear reducer for robot DIY assorted kit- 34 Kindsrobot kits
SKU: 781385- Product: Rack and pinion gear pulley plastic shaft set
- Easy to change when the gear is missing or damaged, as a spare accessory to use.
- Made of high-quality plastic, wearable, and long service life.
- Small parts, easy to use.
SKU: 781385 -
Other ESP WIFI Modules
NodeMCU ESP8266 Serial Port Baseboard Lua WIFI Development Board
SKU: 31313- The perfect solution for breaking out the pins from Lua V3 Nodemcu.
- Lead-out all the IO ports of the ESP-12E development board
- Lead out the pins of 5V and 3.3V power supply
- Convenient to connect with peripheral modules
- Onboard 5V / 1A DC-DC step-down converter circuit
- Onboard power indicator
- With DC power jack 6-24V.
SKU: 31313 -
-
Toroidal Inductors
330uH 5.2A High Current Toroidal DIP Inductor
SKU: 872028- Type: Toroidal
- Material: Core Ferrite
- Inductance: 330µH
- Tolerance: ±20%
- Current Rating (Amps): 5.2A
- Shielding: Unshielded
- Operating Temperature: -40°C ~ 105°C
- Mounting Type: Through-Hole
- Package/Case: Radial, Vertical (Open)
- Dimensions (D x W): (20.00mm x 9.00mm)
SKU: 872028 -
-
Breadboard and Zero PCBs
XD-42 5V/3.3V Dual Channel Solderless Breadboard Power Supply Module
SKU: 368546- Locking On/Off Switch
- Green LED Power Indicator
- Voltage Swapping Switch on both rail Channel
- Its concave design will not waste your proto zone.
- Easy to install on a breadboard with Compact portable size
SKU: 368546 -
LED Module
DIP 3 Color LED Module
SKU: 44177- The use of plug-in full-color LED.
- RGB trichromatic limiting resistor to prevent burnout.
- Through the PWM adjusting, three primary colors can be mixed to obtain different colors.
- With a variety of single-chip interface.
- The working voltage: 5V.
- LED drive mode: common cathode driver
SKU: 44177 -
PVC wire
2 Meter UL1007 20AWG PVC Electronic Wire (Black)
SKU: 528313The use of PVC coating blends these wires with special properties such as self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes.
Self – extinguishing and flame retardant, also Conditionally resistant to oils, solvents, acids, and dyes…
SKU: 528313 -
4S Li-ion BMS
4 Series 40A 18650 Lithium Battery Protection Board 14.8V 16.8V with Balance for Drill Motor Lipo Cell Module
4S Li-ion BMS4 Series 40A 18650 Lithium Battery Protection Board 14.8V 16.8V with Balance for Drill Motor Lipo Cell Module
SKU: 223535- The Successful start of the drill requires three 15C-20C power battery, or six 10C-15C power battery (ordinary 18650 cannot start the drill!!)
- Strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
SKU: 223535 -
-
