CAPUF WCH CH32V003 Programmer/Debugger

The WCH-LinkE module can be used for online debugging and downloading of WCH RISC-V architecture MCU and can also be used for online debugging and downloading for ARM chips with SWD/JTAG interface. A JTAG interface is provided to support four-wire connection (TMS line, TCK line, TDI line and TDO line) to extend the JTAG interface for a computer to operate CPU, DSP, FPGA, CPLD and other devices. Through its USB2.0 full-speed interface, it can be connected to a computer host. It is plug and play. Connected to target chips by the debugging interface, it can be used for debugging and programming.

Useful Link Products – CAPUF

Features:

1. Two 3.3V/5V power supply outputs are supported
2. Supports USB to TTL serial port function
3. Supports RISC-V chip single-wire/dual-wire downloading and debugging
4. Supports downloading and debugging for ARM kernel MCU with SWD/JTAG interface
5. Supports automatic firmware detection and upgrade
6. 3.3V/5V output power supply is controllable
7. Automatic power-off protection
8. Red and blue LED indicator lights make it easy to check the working status
9. Supports a host computer to switch working mode via one key

Specifications:

1. Data bit: 8
2. Stop bit: 1
3. Checksum bit: None
4. Flow control: None
5. Length: 75mm
6. Width: 24mm
7. Height: 15mm

Package Includes:

1 x CAPUF WCH CH32V003 Programmer/Debugger